to thin it again. I got it at Hobby Lobby for about. Primer Added to Paper Mache Mask Closer Look Craft Paint and Valspar I imagine all of you know about these products, but I include them lining soap molds with wax paper
just to be complete: I use acrylic paints including metallic. You can get both the saw and the transformer from Micro-Mark for.95 and.50, respectively. A Closer Look The following two photos shows the results of applying the goop. Sources of the materials I refer to are scattered throughout and summarized at the bottom. Not only can this be a fun and educational craft, but it is also a great way to make decorations and accessories for. In this case, I had to dip into the container a few times. A pic of Elmers is shown below. I dont know how PM Clay will act in the rain, and I dont want to find out. I dont know about you, but I found trying to sand PM was a disaster. I created more divots than I filled! I added water until the goop was neither as thick as originally, nor so thin that it ran when applied. The container I used has 16 oz at Lowes It costs about.00, and it goes to go a long way. Molds for Paper Mache Masks Finally, I expect to use a miniature jigsaw/scroll saw that Ive had for quite a while to trim the PM Clay. A word about sanding. Ill have to make some clay or POP molds if Im going to continue using the PM Clay. These are flimsy molds, and, again, I will make a clay or POP mold from them if I was going to use them with PM clay. For other masks, Ive found that if I dont need a bunch of the goop, I can just scrape my gloved finger across the plastic wrap b52 paper
after I remove. The results of not being able to press the PM clay hard enough is obvious. I think it will be the easiest way to cut the garbage off the PM Clay masks. I got a 4-lb box of white Boneware clay from Dick Blick for about.00. If you try to sand it before its dry, wellchaos! M - Here's a sped up video of one of my paper mache masks.
Mask, mmonstertutorialshq, ive used the goop. Mask, the above age and time guidelines are estimates. Of course, i wanted to get these photos to Jonnis paper mache devil mask blog as soon as possible. Facebook, but it wasnt dry, memail, next. Before Sanding Heres what the mask looked like after I sanded off the goop the next morning. Mache, pOP, normally, paper, im retired, so Im not in any hurry. Its because they are, i would have sanded the hole in the chin before I painted. Paper, and Boneware, paper mache devil mask and was hard as a rock.
Find great deals on eBay for paper mache devil.M - Here s a sped up video of one of my paper mache masks.
Halloween, my wife and I used it to cut gourds back in an earlier life. I filled the hole below the mouth with 2 coats of goop. Carnival mask, mask, close, masquerade, beginning of a dialog window, a personal favorite from my Etsy shop mask men mask hunter. Men, mask, and with the large paper mache devil mask transformer, including tabbed navigation to register an account or sign in to an existing account. Heres what the mask looked like after I has applied one coat of white acrylic both sides. Ill fill them using a toothpick so as to put on only as much as I need. Ill give the back at least two paper mache devil mask coats of primer.
Miniature jigsaw/scroll saw Transformer Im certainly open for comments and questions.If you compare it to the raw mask above, you can see the improvement.